For people who like to ride and
experience the thrills of motorcycling, there is no better activity than
learning how to start a motorcycle. However, how to start a motorcycle can be
daunting at times. Many people want to know what they should do to get their
bike up and running in no time. The following tips will be helpful when you are
ready to learn how to start a motorcycle.
First, check to make sure that your
battery is fully charged and ready to go before you begin your ride. Next,
confirm whether you actually have a fuel-injected or carburetted motorcycle. If
you are using a fuel-injected motorcycle, you will need to drain the gas tank,
refill it with new gas, and add water. Do this before beginning your ride so
that you do not have to do it right away. Also, remember that both types of
motorcycles run differently.
Next, you must connect the chain to
the carburetor. Before doing so, make sure that the motorcycle has cooled down
completely since starting a motorcycle right after running the engine can cause
burns. Place the new battery into the tank and secure it using a bolt. If you
are using a battery that does not require a new housing, place the bolts in a
secure spot and fasten the chain to the new battery. Next, connect the throttle
cables to the carburetor. You should be able to feel the tank tighten as the
screws turn.
Check the carburetor to ensure that
it is not jammed. In case of a stuck carburetor, you will need to remove the
sprocket first, which is next and then the filter. Check the other pipes for
leaks as well. In some cases, these pipes may need to be replaced by a
professional, especially if you are not experienced with motorcycle
maintenance.
The final step in how to start a
motorcycle that has been sitting is to reconnect the fuel lines to the
carburetor hoses. Make sure that they are working correctly before plugging
them back into the engine. Plugging them back into the engine will prevent them
from freezing together, which can cause serious problems with your bike's
electrical system.
When you are learning how to start a
motorcycle with a screwdriver, you need to use the same type of tool that you
would if you were learning how to start a motorcycle with a lift kit. Start by
loosening all the screws that attach the carburetor to the carbs. You will need
to use a screwdriver with a wide head so that it can reach all the way around
the carburetor. Once you have loosened all the screws, remove them from their
holding spots on the carburetor. Your next step is to unbolt the backside of
the carburetor and slide it off the motorcycle. Be careful not to damage any of
the parts when you are doing this process.
Your next step is to locate the
ignition key. On most motorcycles, the key switch is mounted under the seat in
front of the rider. The switch is usually covered by a plastic shield that
slides out when you take your bike out for a spin. Once you have the key switch
out, you can remove it from the mounting plate. Again, be careful not to damage
any of the components when you are doing this procedure.
The final step in how to start a
motorcycle with a screwdriver is to disconnect the battery from the mainboard.
You should do this on the battery side of the bike, because the key switch
usually remains in the same place while the battery is removed. Next, remove
the engine mounts using a long screwdriver. Place the bike on its side and look
down the line where the carburetor and the engine mount meet. The black mark
will represent the starter motor.